Declutter Your Yard: Build Your DIY Wall-Mounted Yard Tool Organizer Today!

Tired of tripping over rakes, shovels, and garden tools every time you step into your shed or garage? This DIY wall-mounted yard tool organizer is the perfect solution!

With easy-to-follow plans, minimal materials, and a few tools, you’ll have your yard essentials neatly stored and always within reach. Plus, this organizer doesn’t just save space—it saves time and frustration!

Supplies Needed

Wood Boards:

• (3) 1 1/2" x 3 1/2" x 8' boards (common 2x4) — approximately 38 mm x 89 mm x 2438 mm.

Fasteners:

• 2 1/2" Kreg pocket hole screws — approximately 64 mm.

Adhesives:

• Wood glue.

Additional Tools:

• Drill with pocket hole jig.

• Table saw.

• Measuring tape.

• Screwdriver.

• Kreg 90-degree pocket hole driver (optional for precision).

Cut List

Panels:

• (4) Panel Tops and Bottoms: 27" (686 mm) each.

• (4) Panel Sides: 27" (686 mm) each.

Base:

• (1) Base: 27" (686 mm) long with a 5-degree bevel on one long edge.

Dividers:

• (5) Dividers: 6" (152 mm) long, each with a 5-degree miter cut on one end.

Step-by-Step Instructions

Step 1: Build Two Panels

1. Drill two pocket holes into each end of the four Panel Sides.

2. Use wood glue and 2 1/2" (64 mm) pocket hole screws to attach two Panel Sides to the ends of one Panel Top.

3. Attach a Panel Bottom to the other ends of the Panel Sides.

4. Repeat these steps to create a second identical panel.

Step 2: Attach the Base

1. Use a table saw to cut a 5-degree bevel along one long edge of the Base.

2. Drill three pocket holes along each long edge of the Base (on the shorter side created by the bevel).

3. Position the flat side of the Base against the bottom edge of one Panel Bottom.

4. Secure the Base with wood glue and 2 1/2" (64 mm) pocket hole screws.

Step 3: Attach Dividers

1. For each Divider, cut a 5-degree miter on one end.

2. Drill two pocket holes into each end of the Dividers.

3. Attach the flat side of the first two Dividers to each end of the Panel Top using wood glue and screws.

4. Add the center Divider and then space the remaining two Dividers equally between the center and the ends.

   • Note: You can adjust the spacing to fit specific tools.

Step 4: Attach the Second Panel

1. Lay out the second panel.

2. Spread wood glue on the ends of each Divider and along the Base.

3. Align the second panel over the assembly and secure the Base to the second Panel Bottom using screws.

4. Secure each Divider to the second panel, ensuring alignment.

   • Tip: Use the Kreg 90-degree pocket hole driver for tight spaces.

Step 5: Install on Wall

1. Locate the studs in the wall where you want to mount the organizer.

2. Use 2 1/2" (64 mm) screws to attach the organizer securely to the studs.

3. Ensure the organizer is level before tightening the screws.

Final Step: Enjoy Your Organizer